Octoplus JTAG Software v.1.7.7 is out!


We have added boot repair via USB and small TP for LG E980, E980H, LG E985T, E986, LG E988, LG E989,
which are detected by PC as "Qualcomm HS-USB QDloader 9008" device! Also added repair via JTAG interface for Gigabyte GSmart G1317D.


Octoplus Box JTAG Software v.1.7.7 Release Notes



  • Added support for the following models:


[size]

اقتباس :- LG E980 - added Dead Boot/Device Repair via USB.
- LG E980H - added Dead Boot Repair via USB.
- LG E985T - added Dead Boot Repair via USB.
- LG E986 - added Dead Boot Repair via USB.
- LG E988 - added Dead Boot Repair via USB.
- LG E989 - added Dead Boot Repair via USB.
- Gigabyte GSmart G1317D - added Dead Boot Repair (thanks to Mr. Dr_Wolodya).

[/size]

  • All pinouts and Repair procedures are described in the manual ("Help" button in Software).


[size]





To repair mentioned above devices via USB, please follow the next three steps:
[/size][list="color: rgb(255, 255, 255); font-family: verdana, geneva, lucida, 'lucida grande', arial, helvetica, sans-serif; background-color: rgb(0, 65, 99);"]

[*]Attach testpoint as shown on Figure 1 in the Software manual and connect your phone using Micro USB cable directly into the mainboard’s USB port
(do NOT use any USB hubs!)

[*]Check PC Device Manager, a new device should appear "Qualcomm HS-USB QDLoader 9008" or "Unknown Device" if you hadn’t installed the driver yet.
Drivers are in {Installation_Folder}\Driver\QHSUSB

[*]Release testpoint and press “EasyRepair” button in the software (or “Connect” button, when in Advanced Mode)

[/list]
[size]


Download Octoplus Box JTAG Software v.1.7.7[/size]